©2021 CopyRight USA Atv parts. All rights reserved.
Universal Motorcycle ATV 12V Heated Grips Warmer Pad Kits with Wires and Switch for Handlebar 7/8 inches
Product categories
- A-Arm (349)
- accessories (2183)
- air filter (497)
- bag (104)
- ball joint (423)
- bearing (975)
- belt (465)
- bolt (623)
- Bracket (1190)
- brake cable (1135)
- brake handle (125)
- brake pads (533)
- Brakes (551)
- bumpers (301)
- bushing (734)
- carburetor (1145)
- cargo box (212)
- chain (209)
- charger (95)
- Clutch and parts (1622)
- connecting rod (130)
- contactor (281)
- Covers (126)
- Crankshaft (196)
- CV Axle (2589)
- cylinder (430)
- disk brake (671)
- Dust cover (410)
- engine crankcase (148)
- exhaust pipe (358)
- fan (187)
- fender (256)
- foot pedal (95)
- fork (123)
- friction disc (307)
- fuel oil filter (202)
- fuel pipe (101)
- fuel tank (133)
- gasket (1190)
- gear wheel (183)
- handguard (118)
- handle (432)
- handlebar (171)
- heat sink (296)
- hub (248)
- ignition (213)
- ignition coil (753)
- intake and exhaust valve (862)
- intake pipe (237)
- light (1071)
- muffler (108)
- Nut (292)
- oil seal (422)
- petrol pump (106)
- protective cover (682)
- rearview mirror (516)
- regulator (131)
- relay solenoid valve (322)
- rim (357)
- seat (139)
- sensor (259)
- shock absorber (1805)
- solenoid (234)
- spring (298)
- sprocket (408)
- starter motor (500)
- Steering Kit (279)
- switch (1189)
- tire (930)
- tool (1502)
- trailer hitch (118)
- water pump (108)
- windscreen and windshield (137)
- Wire harness (69)
Product tags
bearing
bolt
bracket
brake cable
brake disc
brake disk
bushing
bushing block
carburetor
car lamp
car light
centrifugal clutch
clutch
clutch cable
clutch parts
CV Axle
disc-brake
disc brakes
disk brake
exhaust valve
gasket
holder
ignition coil
ignition spark booster
intake and exhaust valve
jump-spark coil
Lamps
latch
Lift Kit
Lights
liner bushing
lining
lowering kit
protective cover
shock absorber
sleeve bushing
spark coil
sparking coil
switch
throttle cable
tire
tool
tyre
washer
wheel hub
Material:Kevlar fiber, Slim heating film,Heated rapidly and evenly.Waterproof Rating:IP67,widely used for most 12V motorcycles, ATV, scooters etc
Working temperature??-40??F~194??F ( -40 degree- 90 degree),Power:High temperature??26W,Middle temperature:20W;Low temperature:13W;Pad dimensions: 12.5 x 10cm.
Press the switch and hold for 5 seconds, the power-on indicator is on, ,over voltage protection intelligently,With 3 positions to controal the tempereture,no-slip and abrasion resistant.
Washing in water approved,easy for Installation,including: 2 x Heated grip pads (with connection wires and on/off switch). 8*Strapping tape
Usage :Connect this Heated Grips Warmer pad to your 12V battery,and it will be heated up in about 1 minutes,it will keep your hands feel warm of the whole winter.DIY creativity, easy to install, just stick on handlebars.
Parameters
1.Suitable for handbar with diameter between
30mm~36mm(1.18in~1.42in)
2.Working temperature:-40??F~194??F





